Delta Electronics AC Motor Drive VFD-VE Series - Filter Time for PTC Detection; Output Frequency for Malfunction; Output AC Voltage for Malfunction; DC Voltage for Malfunction

Chapter 4 Parameters|
4-106 Revision August 2008, 03VE, SW V2.04
Settings 0.0 to 100.0%
 It is used to set the PTC level, and the corresponding value for 100% is max. analog input
value.
06-31  Filter Time for PTC Detection Unit: 0.01
Control
mode
VF VFPG SVC FOCPG TQRPG
Factory Setting: 0.20
Settings 0.00 to 10.00 sec
06-32 Output Frequency for Malfunction Unit: 0.01
Control
mode
VF VFPG SVC FOCPG TQRPG
Factory Setting: 0.00
Settings 0.00 to 655.35 Hz
06-33 Output AC Voltage for Malfunction Unit: 0.1
Control
mode
VF VFPG SVC FOCPG TQRPG
Factory Setting: 0.0
Settings 0.0~6553.5 V
06-34 DC Voltage for Malfunction Unit: 0.1
Control
mode
VF VFPG SVC FOCPG TQRPG
Factory Setting: 0.0
Settings 0.0~6553.5 V
06-35 Current Value for Malfunction Unit: 0.01
Control
mode
VF VFPG SVC FOCPG TQRPG
Factory Setting: 0.00
Settings 0.00~655.35 Amp
06-36 IGBT Temperature for Malfunction Unit: 0.1
Control
mode
VF VFPG SVC FOCPG TQRPG
Factory Setting: 0.0
Settings 0.0~6553.5 °C