Diamond DA 62 - 6.9 Cruise; Use of the Auxiliary Fuel Tanks

Normal Operating
Procedures
DA 62 AFM
4A.6.9 CRUISE
1. POWER lever. . . . . . . . . . . . . . . . . . . . . . . . . up to 95%
NOTE
The recommended cruise power setting is 75%.
2. Trim . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . as required
3. Annunciations/Engine/System Page . . . . . . . monitor
Use of the Auxiliary Fuel Tanks (if installed)
CAUTION
When operating the AUX PUMP LH/RH switch, make sure
not to exceed the fuel imbalance limitations given in
Section 2.14 - FUEL.
To avoid additional imbalance in the auxiliary tanks both
AUX PUMP switches must be operated simultaneously.
1. Transfer the first half of the auxiliary fuel:
As soon as the fuel quantity in each main fuel tank is 15 US gal or less, set both
AUX PUMP switches to ON until the main tanks are full again.
Monitor the fuel quantity indicator to verify that fuel is properly transferred to both main
fuel tanks (approx. 1 US gal per minute). If the fuel quantity in a main tank does not
increase during fuel transfer, proceed according to Section 4B.10 - L/R FUEL
TRANSFER FAIL.
CONTINUED
Page 4A - 44 Rev. 0 11-Jan-2019 Doc. No. 11.01.05-E