Normal Operating
Procedures
DA 62 AFM
NOTE
If the altitude preselect is not changed before selecting VS,
the autopilot may re-capture the current altitude immediately
after entering VS mode. Always ensure that the altitude
preselect is adjusted prior to selecting VS.
The vertical speed mode is limited to 1500 ft/min climb and
3000 ft/minute descent. Use engine power to maintain
appropriate airplane speed. If the CWS switch is used while
in VS mode, the VS reference will change to the vertical
speed when the CWS switch is released.
END OF CHECKLIST
b) Flight Level Change (FLC)
1. Altitude preselect . . . . . . . . . . . . . . . . . . . . . . set to desired altitude
2. Mode controller . . . . . . . . . . . . . . . . . . . . . . . select FLC on mode controller
3. Airspeed speed reference . . . . . . . . . . . . . . . adjust using NOSE UP and NOSE
DN buttons
4. White ALT (altitude preselect armed) . . . . . . note on PFD
5. Green ALT . . . . . . . . . . . . . . . . . . . . . . . . . . . verify upon altitude capture
CONTINUED
Page 4A - 46 Rev. 0 11-Jan-2019 Doc. No. 11.01.05-E
To Next Page
Loading...
