Diamond DA 62 - Operation with Anti-Icing Fuel Additives

Operating Limitations DA 62 AFM
CAUTION
In case of an unknown or an over dosage of the fuel additives
the fuel system must be purged until the dosage is within the
permitted limits.
NOTE
The specified additives are qualified for the operation with
the certified fuel grades.
NOTE
The instructions of the fuel additive supplier must be followed.
OPERATION WITH ANTI-ICING FUEL ADDITIVES
The application of the following additive is permitted:
- PRIST Hi-Flash : max. 1500 ppm
CAUTION
The use of PRIST Hi-Flash fuel additive is only permitted with
JET A, JET A-1 (ASTM D 1655) and JP-8 (F34).
NOTE
The instructions of the fuel additive supplier must be followed.
Page 2 - 28 Rev. 0 11-Jan-2019
DOT
approved
Doc. No. 11.01.05-E