Interfaces Wide Area Networks (WANs)
AnywhereUSB® Plus User Guide
161
b. Set the IPv6 type to DHCP:
(config network interface my_wan)> ipv6 type dhcpv6
(config network interface my_wan)>
c. Generally, the default settings for IPv6 support are sufficient. You can view the default IPv6
settings by using the question mark (?):
(config network interface my_wan)> ipv6 ?
IPv6
Parameters Current Value
---------------------------------------------------------------------
----------
dhcp_hostname false DHCP Hostname
enable true Enable
metric 0 Metric
mgmt 0 Management priority
mtu 1500 MTU
type dhcpv6 Type
use_dns always Use DNS
weight 10 Weight
Additional Configuration
---------------------------------------------------------------------
----------
connection_monitor Active recovery
(config network interface my_wan)>
d. Modify any of the remaining default settings as appropriate. For example, to change the
metric:
(config network interface my_wan)> ipv6 metric 1
(config network interface my_wan)>
If the minimum length is not available, then a longer prefix will be used.
See Configure WAN/WWAN priority and default route metrics for further information about
metrics.
(Optional) Configure the MAC address deny list.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address denylist.
a. Add a MACaddress to the denylist:
(config network interface my_wan)> add mac_denylist end mac_address
(config network interface my_wan)>
where mac_address is a hyphen-separated MAC address, for example, 32-A6-84-2E-81-58.
b. Repeat for each additional MACaddress.
(Optional) Configure the MAC address allowlist.
To Next Page
Loading...
Need help?
General