Digi AnywhereUSB Plus User Manual

User authentication AnywhereUSB Plus user authentication
AnywhereUSB® Plus User Guide
310
AnywhereUSB Plus user authentication
User authentication on the AnywhereUSB Plus has the following features and default configuration:
Feature Description
Default
configuration
Idle timeout
Determines how long a user session can be idle before the
system automatically disconnects.
n
10 minutes.
Allow shell If disabled, prevents all authentication prohibits access to
the shell prompt for all authentication groups. This does not
prevent access to the Admin CLI.
Note If shell access is disabled, re-enabling it will erase the
device's configuration and perform a factory reset.
n
Enabled.
Methods
Determines how users are authenticated for access:
local
users
,
TACACS+
, or
RADIUS
.
n
local users.
Groups
Associates access permissions for a group. . You can modify
the released groups and create additional groups as needed
for your site. A user can be assigned to more than one group.
n
admin: Provides
the logged-in
user with
administrative
and shell
access.
n
serial: Provides
the logged-in
user with access
to serial ports.
Users
Defines local users for the
AnywhereUSB Plus
.
n
admin: Belongs
to both the
admin and
serial groups.
TACACS+
Configures support for TACACS+ (Terminal Access Controller
Access-Control System Plus) servers and users.
n
Not configured.
RADIUS
Configures support for RADIUS (Remote Authentication Dial-
In User Service) servers and users.
n
Not configured.
LDAP
Configures support for LDAP (Lightweight Directory Access
Protocol) servers and users.
n
Not configured.
Serial
Configures authentication for serial TCP and autoconnect
services.
n
Not
configured.
User authentication methods
Authentication methods determine how users of the AnywhereUSB Plus device are authenticated.
Available authentication methods are:

Digi AnywhereUSB Plus Specifications

General

Brand	Digi
Model	AnywhereUSB Plus
Category	Switch
Language	English