Digi AnywhereUSB Plus User Manual

Command line interface Device configuration using the command line interface
AnywhereUSB® Plus User Guide
680
show system
The show system command displays system information and statistics for the device, including CPU
usage.
> show system
Model : Digi AnywhereUSB Plus
Serial Number : AnywhereUSB Plus-000065
SKU : AnywhereUSB Plus
Hostname : AnywhereUSB Plus
MAC Address : DF:DD:E2:AE:21:18
Hardware Version : 50001947-01 1P
Firmware Version : 21.8.24.120
Alt. Firmware Version : 21.8.24.120
Alt. Firmware Build Date : Mon, 13 September 2021 8:04:23
Bootloader Version : 19.7.23.0-15f936e0ed
Current Time : Mon, 13 September 2021 8:04:23 +0000
CPU : 1.4%
Uptime : 6 days, 6 hours, 21 minutes, 57 seconds (541317s)
Temperature : 40C
>
show network
The show network command displays status and statistics for network interfaces.
> show network
Interface Proto Status Address
---------------- ----- ------- -------------------------------
defaultip IPv4 up 192.168.210.1/24
defaultlinklocal IPv4 up 169.254.100.100/16
lan IPv4 up 192.168.2.1
lan IPv6 up 0:0:0:0:0:ffff:c0a8:301
loopback IPv4 up 127.0.0.1/8
wan IPv4 up 192.168.3.1/24
wan IPv6 up fd00:2704::240:ffff:fe80:120/64
>
Device configuration using the command line interface
The config command allows for device configuration from the command line. All configuration tasks
that can be performed by using the WebUI can also be performed by using the config command.
There are two ways to invoke the config command from the CLI:
n
Execute the config command and parameters at the root prompt. See Execute configuration
commands at the root Admin CLI prompt for more information.
n
Enter configuration mode by executing the config command without any parameters. See
Configuration mode for more information.

Digi AnywhereUSB Plus Specifications

General

Brand	Digi
Model	AnywhereUSB Plus
Category	Switch
Language	English