Command line interface Execute configuration commands at the root Admin CLI prompt
AnywhereUSB® Plus User Guide
681
Execute configuration commands at the root Admin CLI prompt
You can execute the config command at the root Admin CLI prompt with any appropriate parameters.
When the config command is used in this way, changes to the device's configuration are
automatically saved when the command is executed.
For example, to disable the SSHservice from the root prompt, enter the following command:
> config service ssh enable false
>
The AnywhereUSB Plus device's ssh service is now disabled.
Note When the config command is executed at the root prompt, certain configuration actions that are
available in configuration mode cannot be performed. This includes validating configuration changes,
canceling and reverting configuration changes, and performing actions on elements in lists. See
Configuration mode for information about using configuration mode.
Display help for the config command from the root Admin CLI
prompt
Display additional configuration commands, as well as available parameters and values, by entering
the question mark (?) character after the config command.
1. For example:
> config ?
Will display the following help information:
> config ?
Additional Configuration
-------------------------------------------------------------------------
-
application Custom scripts
auth Authentication
cloud Central management
firewall Firewall
monitoring Monitoring
network Network
serial Serial
service Services
system System
vpn VPN
Run "config" with no arguments to enter the configuration editing mode.
> config
2. You can then display help for the additional configuration commands. For example, to display
help for the config service command:
To Next Page
Loading...
Need help?
General