Digi AnywhereUSB Plus

Configure the AnywhereUSB Manager from the command line power cycle
AnywhereUSB® Plus User Guide
774
power cycle
Purpose
This command enables you to power cycle a selected USBdevice.
The USBdevice can be connected directly to the AnywhereUSB Hub or to a downstream USBhub.
This resets the USB device and has the same effect as removing the USB device from the Hub and
then reconnecting it.
Note If an externally powered USB device (one that is not powered by the Hub) is connected to the
Hub, the power cycle feature may have no effect on the USBdevice.
The USBdevice you choose to power cycle must be assigned to a group that you are allowed to
access. When you use this feature, the power supplied by the port to the USBdevice is turned off and
then turned on.
Note You can also perform a power cycle of a USBdevice from the AnywhereUSBManager. See Cycle
the power to a USB device connected to the Hub from the AnywhereUSBManager.
Syntax
>awusbmanager power cycle,<device address>
Example
Run the list command to get the device address. In this example, the device address is AW08-
000016.1905.
awusbmanager.exe POWER CYCLE,AW08-000016.1905