Interfaces Wide Area Networks (WANs)
AnywhereUSB® Plus User Guide
175
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Use the del command to delete the WANor WWAN. For example, to delete a WWANnamed
my_wwan:
(config)> del network interface my_wwan
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Default outbound WAN/WWAN ports
The following table lists the default outbound network communications for AnywhereUSB Plus
WAN/WWAN interfaces:
Description TCP/UDP Port number
Digi Remote Manager
connection to
my.devicecloud.com
TCP 3199
NTP date/time sync to time.devicecloud.com UDP 123
DNS resolution using WAN-provided DNS servers UDP 53
HTTPS for modem firmware downloads from firmware.accns.com TCP 443
To Next Page
Loading...
Need help?
General