EasyManuals Logo

Digi AnywhereUSB Plus User Manual

Digi AnywhereUSB Plus
815 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #795 background imageLoading...
Page #795 background image
Software and reference Additional power and cabling requirements:AnywhereUSB Plus 8 and 24
AnywhereUSB® Plus User Guide
795
Additional power and cabling requirements:AnywhereUSB Plus 8
and 24
Note This information applies only to the AnywhereUSB Plus 8 and 24 variants.
Use an appropriate power cable meeting national standards to connect to a standard outlet. The
appropriate
requirements are listed per region:
n
EU/International: VDE Mark, conforming to IEC 60083, IEC 60227, or IEC 60320, with C13 to the
appropriate national mains connector, rated for the national mains voltage for your
EU/International country.
3 x 0.823 mm2
n
USA/Canada: UR Mark, conforming to UL 62, UL 817, or CSA-C22.2, with C13 to 5-15P, 5-15P, or
NEMA locking connector, 18 AWG.
The male cable connector to the device is a 2ESDVM-02P (Dinkle). The product is certified and
intended for use only with the Digi provided power supply. Use with 3rd party supplies is not covered
by the Digi warranty.
Software and reference
Uninstall the AnywhereUSBManager using Windows
You can uninstall the AnywhereUSBManager if needed.
Note You can also uninstall the AnywhereUSBManager from the Windows Control Panel. In addition,
you can uninstall the Manager using Linux from the AnywhereUSB 2 Plus and the AnywhereUSB 8
Plus.
1. Locate the AnywhereUSBManager installer. You must run the same version of the installer to
uninstall the AnywhereUSB Manager that you used to install it.
n
If you saved the installer when you originally installed the AnywhereUSBManager,
navigate to that location on your computer.
n
If you did not, you can download the installer from the Support Tools website.
a. Navigate to https://www.digi.com/support#support-tools.
b. From the Support Downloads section, click Drivers.
c. Find and select AnywhereUSB Plus from the product list.
d. Select your AnywhereUSB Plus model.
e. Select and download the appropriate software for your operating system.
2. Click on the downloaded software to launch the AnywhereUSB Manager installation wizard.
The Welcome screen appears.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Digi AnywhereUSB Plus and is the answer not in the manual?

Digi AnywhereUSB Plus Specifications

General IconGeneral
BrandDigi
ModelAnywhereUSB Plus
CategorySwitch
LanguageEnglish

Related product manuals