User authentication Local users
AnywhereUSB® Plus User Guide
326
Local users
Local users are authenticated on the device without using an external authentication mechanism such
as TACACS+ or RADIUS. Local user authentication is enabled by default, with one preconfiged default
user.
Default user
At manufacturing time, each AnywhereUSB Plus device comes with a default user configured as
follows:
n
Username: admin.
n
Password: The default password is displayed on the label on the bottom of the device.
Note The default password is a unique password for the device, and is the most critical
security feature for the device. If you reset the device to factory defaults, you must log in using
the default user and password, and you should immediately change the password to a custom
password. Before deploying or mounting the AnywhereUSB Plus device, record the default
password, so you have the information available when you need it even if you cannot
physically access the label on the bottom of the device.
The default admin user is preconfigured with both Admin and Serial access. You can configure the
admin user account to fit with the needs of your environment.
This section contains the following topics:
Change a local user's password 327
Configure a local user 329
Delete a local user 336
To Next Page
Loading...
Need help?
General