User authentication Terminal Access Controller Access-Control System Plus (TACACS+)
AnywhereUSB® Plus User Guide
339
Terminal Access Controller Access-Control System Plus
(TACACS+)
Your AnywhereUSB Plus device supports Terminal Access Controller Access-Control System Plus
(TACACS+), a networking protocol that provides centralized authentication and authorization
management for users who connect to the device. With TACACS+ support, the AnywhereUSB Plus
device acts as a TACACS+ client, which sends user credentials and connection parameters to a
TACACS+ server over TCP. The TACACS+ server then authenticates the TACACS+ client requests and
sends back a response message to the device.
When you are using TACACS+ authentication, you can have both local users and TACACS+ users able
to log in to the device. To use TACACS+ authentication, you must set up a TACACS+ server that is
accessible by the AnywhereUSB Plus device prior to configuration. The process of setting up a
TACACS+ server varies by the server environment.
This section contains the following topics:
TACACS+ user configuration 340
TACACS+ server failover and fallback to local authentication 341
Configure your AnywhereUSB Plus device to use a TACACS+ server 341
To Next Page
Loading...
Need help?
General