Configuration and management Using Digi Remote Manager
AnywhereUSB® Plus User Guide
85
Using Digi Remote Manager
By default, your AnywhereUSB Plus device is configured to use Digi Remote Manager as its central
management server. No configuration changes are required to begin using the Remote Manager.
For information about configuring central management for your AnywhereUSB Plus device, see
Central management.
Access Digi Remote Manager
To access Digi Remote Manager:
1. If you have not already done so, go to https://myaccount.digi.com/ to sign up for a Digi Remote
Manager account.
Check your email for Digi Remote Manager login instructions.
2. Go to remotemanager.digi.com.
1. Enter your username and password.
The Digi Remote Manager Dashboard appears.
Use the local RESTAPI to configure the AnywhereUSB Plus
device
Your AnywhereUSB Plus device includes a RESTAPI that can be used to return information about the
device's configuration and to make modifications to the configuration. You can view the RESTAPI
specification from your web browser by opening the URL:
https://ip-address/cgi-bin/config.cgi
For example:
https://192.168.210.1/cgi-bin/config.cgi
Use the GETmethod to return device configuration information
To return device configuration, issue the GET method. For example, using curl:
$ curl -k -u admin https://ip-address/cgi-bin/config.cgi/value/path -X GET
where:
n
ip-address is the IP address of the AnywhereUSB Plus device.
n
path is the path location in the configuration for the information being returned.
To determine allowed values for path from the Admin CLI:
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access
selection menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
To Next Page
Loading...
Need help?
General