Configure the AnywhereUSB in the web user interface View Hub system information
AnywhereUSB® Plus User Guide
99
If a USB device is connected to the port, the USB device is powered off and then powered back on,
which has the same effect as removing the USB device from the Hub and then reconnecting it.
Note If an externally powered USB device (one that is not powered by the Hub) is connected to the
Hub, the power cycle feature may have no effect on the USBdevice.
Note In addition, you can power cycle a selected USBdevice from the AnywhereUSBManager. See
Cycle the power to a USB device connected to the Hub from the AnywhereUSBManager.
1. Open the web UI.
2. Click Status > AnywhereUSB. The AnywhereUSBStatus page displays.
3. Click Cycle for the port that you want power off and then on.
4. When the power cycle is complete, a success message displays.
View Hub system information
You can view current status information about the Hub in the Dashboard. This page appears by
default when you launch the web UI.
1. Open the web UI. The Dashboard appears by default when you launch the web UI.
2. In the AnywhereUSB Service pane, click Show Details to display additional information in the
AnywhereUSBStatus page.
USBDevices
Click USB Devices to expand this section and display information about the USB devices connected to
the AnywhereUSB.
To Next Page
Loading...
Need help?
General