Command line interface Configuration mode
AnywhereUSB® Plus User Guide
690
a. To delete the local authentication method, use the index number 0:
(config)> del auth method 0
(config)>
b. Use the show command to verify that the local authentication method was removed:
(config)> show auth method
0 tacacs+
1 radius
(config)>
Move elements within a list
Use the move command to reorder elements in a list.
For example, to reorder the authentication methods:
1. Use the show command to display current authentication method configuration:
(config)> show auth method
0 local
1 tacacs+
2 radius
(config)>
2. To configure the device to use TACACS+ authentication first to authenticate a user, use the
move index_number_1 index_number_2 command:
(config)> move auth method 1 0
(config)>
3. Use the show command again to verify the change:
(config)> show auth method
0 tacacs+
1 local
2 radius
(config)>
The revert command
The revert command is used to revert changes to the AnywhereUSB Plus device's configuration and
restore default configuration settings. The behavior of the revert command varies depending on
where in the configuration hierarchy the command is executed, and whether the optional path
parameter is used. After executing the revert command, you must save the configuration changes by
using the save command. You can also discard the configuration changes by using the cancel
command.
CAUTION! The revert command reverts all changes to the default configuration, not only
unsaved changes.
To Next Page
Loading...
Need help?
General