Command line interface Configuration mode
AnywhereUSB® Plus User Guide
689
(config)> add auth method 0 tacacs+
(config)> show auth method
0 tacacs+
1 local
(config)>
n
To add the TACACS+ authentication method to the end of the list, use the end keyword:
(config)> add auth method end tacacs+
(config)> show auth method
0 local
1 tacacs+
(config)>
The end keyword
As demonstrated above, the end keyword is used to add an element to the end of a list. Additionally,
the end keyword is used to add an element to a list that does not have any elements.
For example, to add an authentication group to a user that has just been created:
1. Use the show command to verify that the user is not currently a member of any groups:
(config)> show auth user new-user group
(config)>
2. Use the end keyword to add the admin group to the user's configuration:
(config)> add auth user new-user group end admin
(config)>
3. Use the show command again to verify that the admin group has been added to the user's
configuration:
(config)> show auth user new-user group
0 admin
(config)>
Delete elements from a list
When used with parameters that contains lists of elements, the del command is used to delete an
element in the list.
For example, to delete an authentication method:
1. Use the show command to display current authentication method configuration:
(config)> show auth method
0 local
1 tacacs+
2 radius
(config)>
2. Delete one of the authentication methods by using the del index_number command. For
example:
To Next Page
Loading...
Need help?
General