Interfaces Wide Area Networks (WANs)
AnywhereUSB® Plus User Guide
163
l
SureLink active recovery configuration. See Configure SureLink active recovery to detect
WAN/WWAN failures for further information.
n
IPv6 configuration:
l
The metric for IPv6 routes associated with the WAN.
l
The relative weight for IPv6 routes associated with the WAN.
l
The IPv6 management priority of the WAN. The active interface with the highest
management priority will have its address reported as the preferred contact address for
central management and direct device access.
l
The IPv6 Maximum Transmission Unit (MTU) of the WAN.
l
When to use DNS: always, never, or only when this interface is the primary default route.
l
SureLink active recovery configuration. See Configure SureLink active recovery to detect
WAN/WWAN failures for further information.
ÉWebUI
1. Log into the AnywhereUSB Plus WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Network > Interfaces.
4. Create the WWAN or select an existing WWAN:
n
To create a new WWAN, for Add interface, type a name for the WWAN and click g.
n
To edit an existing WWAN, click to expand the WWAN.
New WWANs are enabled by default. To disable, click Enable.
To Next Page
Loading...
Need help?
General