Digi AnywhereUSB Plus

Interfaces Local Area Networks (LANs)
AnywhereUSB® Plus User Guide
180
a. Click to expand MACaddress allowlist.
b. For Add MACaddress, click g.
c. Type the MAC address.
14. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new LAN or edit an existing one:
n
To create a new LAN named my_lan:
(config)> add network interface my_lan
(config network interface my_lan)>
n
To edit an existing LAN named my_lan, change to the my_lan node in the configuration
schema:
(config)> network interface my_lan
(config network interface my_lan)>
4. Set the appropriate firewall zone:
(config network interface my_lan)> zone zone
(config network interface my_lan)>
See Firewall configuration for further information.
5. Select an Ethernet device or a bridge. See Bridging for more information about bridging.
a. Enter device ? to view available devices and the proper syntax.
(config network interface my_lan)> device ?
Current value:
(config network interface my_lan)> device