Services System time
AnywhereUSB® Plus User Guide
280
4. (Optional) For Timezone, select either UTC or select the location nearest to your current
location to set the timezone for your AnywhereUSB Plus device. The default is UTC.
5. (Optional) Add upstream NTP servers that the device will use to synchronize its time. The
default setting is time.devicecloud.com.
n
To change the default value of the NTP server:
a. Click NTP servers.
b. For Server, type a new server name.
n
To add an NTPserver:
a. Click NTP servers.
b. For Add Server, click g.
c. For Server, enter the hostname of the upstream NTPserver that the device will use
to synchronize its time.
d. Click gto add additional NTP servers. If multiple servers are included, servers are
tried in the order listed until one succeeds.
Note This list is synchronized with the list of servers included with NTP server configuration,
and changes made to one will be reflected in the other. See Configure the device as an NTP
server for more information about NTP server configuration.
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. (Optional) Set the timezone for the location of your AnywhereUSB Plus device. The default is
UTC.
(config)> system time timezone value
(config)>
Where value is the timezone using the format specified with the following command:
(config)> system time timezone ?
Timezone: The timezone for the location of this device. This is used to
adjust the time for log
To Next Page
Loading...
Need help?
General