User authentication Example user configuration
AnywhereUSB® Plus User Guide
368
iii. Verify that the admin group has Admin access enabled. If not, click Admin access to
enable.
iv. Verify that Access level is set to Full access. If not, select Full access.
7. Click Apply to save the configuration and apply the change.
Command line
1. Configure a user on the RADIUSserver:
a. On the ubuntu machine hosting the FreeRadius server, open the /etc/freeradius/3.0/users
file:
$ sudo gedit /etc/freeradius/3.0/users
b. Add a RADIUSuser to the users file:
admin1 Cleartext-Password := "password1"
Unix-FTP-Group-Names := "admin"
In this example:
n
The user's username is admin1.
n
The user's password is password1.
n
The authentication group on the AnywhereUSB Plus device, admin, is identified in
the Unix-FTP-Group-Names parameter.
c. Save and close the users file.
2. Configure a user on the TACACS+ server:
a. On the ubuntu machine hosting the TACACS+ server, open the /etc/tacacs+/tac_plus.conf
file:
$ sudo gedit /etc/tacacs+/tac_plus.conf
b. Add a TACACS+ user to the tac_plus.conf file:
user = admin1 {
name ="Admin1 for TX64"
pap = cleartext password1
service = system {
groupname = admin
}
}
}
In this example:
n
The user's username is admin1.
n
The user's password is password1.
To Next Page
Loading...
Need help?
General