Manage the Hubs using the AnywhereUSB Manager
You can use the AnywhereUSB Manager to view the AnywhereUSB Plus Hubs that are allowed to
connect to your computer. You can also connect to groups of USBports on the Hubs.
By default, the AnywhereUSBManager is configured to automatically discover Hubs that are
connected to the same network as your computer. You can allow a connection to additional Hubs that
are not on the same network.
Note Before you begin, make sure you have installed the AnywhereUSB Manager.
Launch the AnywhereUSB Manager 50
Rename AnywhereUSB Hubs, groups, and USBdevices 50
Change the admin password on the Hub 51
Disconnect from a group or USB device 52
Manage the list of known Hubs 54
Hide an individual Hub 56
Hide all unauthorized Hubs 58
Use all Hub addresses 58
Minimize the AnywhereUSB Manager when launched 59
Autofind Hubs in the AnywhereUSBManager 59
Specify search, response, and keepalive intervals for a Hub 59
Cycle the power to a USB device connected to the Hub from the AnywhereUSBManager 60
Manage Hub credentials 61
View latency graph 62
Create support log file 63
Always display the AnywhereUSB Manager on top 63
View the AnywhereUSB Manager system messages 64
View AnywhereUSB version and license information 64
Restore AnywhereUSBManager default configuration 64
Access the online help from the AnywhereUSBManager 65
AnywhereUSB Manager window 65
Exit the AnywhereUSB Manager 78
AnywhereUSB® Plus User Guide
49
To Next Page
Loading...
Need help?
General