Virtual Private Networks (VPN) IPsec
AnywhereUSB® Plus User Guide
575
Set an IPv4 formatted ID. This can be a fully-qualified domain name or an IPv4
address.
(config vpn ipsec tunnel ipsec_example)> local id type ipv4_id
id
(config vpn ipsec tunnel ipsec_example)>
n
ipv6: The ID will be interpreted as an IPv6 address and sent as an ID_IPV6_ADDR
IKE identity.
Set an IPv6 formatted ID. This can be a fully-qualified domain name or an IPv6
address.
(config vpn ipsec tunnel ipsec_example)> local id type ipv6_id
id
(config vpn ipsec tunnel ipsec_example)>
n
rfc822: The ID will be interpreted as an RFC822 (email address).
Set the IDin internet email address format:
(config vpn ipsec tunnel ipsec_example)> local id type rfc822_id
id
(config vpn ipsec tunnel ipsec_example)>
n
fqdn: The ID will be interpreted as FQDN (Fully Qualified Domain Name) and sent as
an ID_FQDN IKE identity.
n
keyid: The ID will be interpreted as a Key ID and sent as an ID_KEY_ID IKE identity.
Set the key ID:
(config vpn ipsec tunnel ipsec_example)> local id type keyid_id
id
(config vpn ipsec tunnel ipsec_example)>
n
mac_address: The device's MACaddress will be used for the Key ID and sent as an
ID_KEY_ID IKE identity.
n
serial_number: The ID device's serial number will be used for the Key ID and sent
as an ID_KEY_ID IKE identity.
14. Configure the remote endpoint:
a. Add a remote hostname:
(config vpn ipsec tunnel ipsec_example)> add remote hostname end value
(config vpn ipsec tunnel ipsec_example)>
where value is the hostname or IPv4 address of the IPsec peer. If your device is not
configured to initiate the IPsec connection (see ike initiate), you can also use the keyword
any, which means that the hostname is dynamic or unknown.
Repeat for additional hostnames.
To Next Page
Loading...
Need help?
General