Virtual Private Networks (VPN) IPsec
AnywhereUSB® Plus User Guide
591
l
Initial connection time: The amount of time to wait for an initial connection to
the interface before this test is considered to have failed.
Allowed values are any number of weeks, days, hours, minutes, or seconds, and
take the format number{w|d|h|m|s}.
For example, to set Initial connection time to ten minutes, enter 10m or 600s.
The default is 60 seconds.
14. Click Apply to save the configuration and apply the change.
Command line
1. Log into the AnywhereUSB Plus command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new IPsec tunnel, or edit an existing one:
n
To create a new IPsec tunnel, see Configure an IPsec tunnel.
n
To edit an existing IPsec tunnel, change to the IPsec tunnel's node in the configuration
schema. For example, for an IPsec tunnel named ipsec_example, change to the ipsec_
example node in the configuration schema:
(config)> vpn ipsec tunnel ipsec_example
(config vpn ipsec tunnel ipsec_example)>
4. Enable active recovery:
(config vpn ipsec tunnel ipsec_example)> connection_monitor enable true
(config vpn ipsec tunnel ipsec_example)>
5. To configure the device to restart the interface when its connection is considered to have
failed:
(config vpn ipsec tunnel ipsec_example)> connection_monitor restart true
(config vpn ipsec tunnel ipsec_example)>
This is useful for interfaces that may regain connectivity after restarting, such as a cellular
modem.
6. To configure the device to reboot when the interface is considered to have failed:
(config vpn ipsec tunnel ipsec_example)> connection_monitor reboot enable
(config vpn ipsec tunnel ipsec_example)>
To Next Page
Loading...
Need help?
General