Command line interface Command line reference
AnywhereUSB® Plus User Guide
733
port
Specifies the destination port base traceroute will use (the destination port number will be
incremented by each probe). A value of -1 specifies that no specific port will be used.
Syntax: INT
Minimum: -1
Default: -1
src_addr
Chooses an alternative source address. Note that you must select the address of one of the interfaces.
By default, the address of the outgoing interface is used.
Syntax: STRING
Optional: True
tos
For IPv4, set the Type of Service (ToS) and Precedence value. Useful values are 16 (low delay) and 8
(high throughput). Note that in order to use some TOS precedence values, you have to be super user.
For IPv6, set the Traffic Control value. A value of -1 specifies that no value will be used.
Syntax: INT
Minimum: -1
Default: -1
waittime
Determines how long to wait for a response to a probe.
Syntax: INT
Minimum: 1
Default: 5
host
The host that we wish to trace the route packets for.
Syntax: STRING
To Next Page
Loading...
Need help?
General