Username and Password
10 Chapter 1
Username and Password
The Digi CM comes with two default users within the user groups, root and
system admin.
Port administrators and users can easily be added by the system admin or root
user through the web interface under System administration > User
administration > Add user. Root’s password must be modified from the
command line using the command passwd.
Ways to Configure the Digi CM
There are three ways to configure the Digi CM. The three ways are:
• Web Interface
• Configuration Menu
• Command Line Interface
Web Interface
The web interface provides a simple, convenient way to configure the Digi CM.
It is accessible to all users, although not all users have the same access
privileges. Root and the system administrator have full access rights to the
web interface. The port administrator is allowed to access and configure the
ports including port clustering, but cannot modify system settings. Users can
also access the web interface, but are only permitted to access the ports.
To access the web interface, enter the IP address or Hostname for the Digi CM
in the URL of a browser page. The following page is displayed after you have
logged into the Digi CM. The menu on the left side of the page cascades as
you select the main heading.
Root’s password
can be modified
through the
command line
interface using the
command passwd.
Username Default Password
root dbps
admin admin
The Digi web
interface features
HTTPS for secure
access.
To Next Page
Loading...
