Ways of Accessing the Digi CM
12 Chapter 1
Telnet to the IP address of the Digi CM with port number 7000.
An example of the command is: telnet 192.168.100.200 7000
Accessing A Port Through the web interface
1. Access the web interface.
2. Choose a Port number or the Port Title.
A Java applet opens with a login prompt.
Direct Port Access
The Digi CM allows you to connect directly to a single port through a Telnet or
SSH session. Before you access a port using this method you need to make
sure the port you are connecting to has been configured properly. The Host
Mode Configuration must be set to Console Server Mode and the Protocol
setting must be set to either Telnet or SSH. All ports are set to Console Server
Mode and Telnet by default.
Telnet to a Port
Using a Telnet client, establish a connection to the IP address of the Digi
CM, followed by the port number of the port you wish to connect. For exam-
ple, to connect to port 3 of the Digi CM, simply enter the following com-
mand:
To Next Page
Loading...
