IX30 User Guide
8
Configure a Local Area Network (LAN) 151
Configure the WAN/ETH1 port as a LAN or in a bridge 158
Change the default LAN subnet 166
Show LAN status and statistics 168
Delete a LAN 169
DHCP servers 171
Default services listening on LANports 188
Configure an interface to operate in passthrough mode. 188
Virtual LANs (VLANs) 195
Create a trunked VLAN route 196
Create a VLAN using switchport mode 198
Bridging 201
Configure a bridge 202
Show Surelink status and statistics 205
Show Surelink status for all interfaces 205
Show Surelink status for a specific interface 205
Show Surelink status for all IPsec tunnels 206
Show Surelink status for a specific IPsec tunnel 206
Show Surelink status for all OpenVPN clients 207
Show Surelink status for a specific OpenVPN client 207
Serial port
Default serial port configuration 209
Serial mode options 209
View serial port information 209
Default serial port configuration 209
Configure Login mode 210
Configure Remote Access mode 213
Configure Application mode 229
Configure PPP dial-in mode 231
Configure UDP serial mode 238
Configure Modbus mode 249
Configure RealPort mode using the Digi Navigator 252
Installation and configuration process 252
Digi Navigator features 252
Install the Digi Navigator 253
Configure RealPort on a Digi device from the Digi Navigator 254
Digi Navigator application features 256
Electrical Signalling Mode 259
Change the electrical signalling mode to RS-232 260
Change the electrical signalling mode to RS-422 261
Change the electrical signalling mode to RS-485 263
Advanced RealPort configuration without using the Digi Navigator 265
Windows Operating System 265
Linux Operating System 265
Download the RealPort driver 266
Configure RealPort on your laptop 266
Configure the serial port for RealPort mode 268
Configure the RealPort service 270
Show serial status and statistics 271
Log serial port messages 271
To Next Page
Loading...
Need help?
General
