Digital Projection E-Vision 7500 Series - Page 68

Digital Projection E-Vision 7500 Series THE OPERATION COMMANDS Remote Communications Guide
62
Rev D July 2014
...continued from previous page
<operation> <command> <values> Notes
green.gain = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
blue.gain = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
sharp = ? + - 0 ~ 31 Not applicable in STANDBY mode or without signal
locked.
nr = ? + - 0 ~ 15 Noise Reduction
Not applicable in STANDBY mode or without signal
locked.
aspect = ? 0 = 5:4
1 = 4:3
2 = 16:10
3 = 16:9
4 = 1.88
5 = 2.35
6 = Letterbox
7 = Native
8 = Unscaled
Not applicable in STANDBY mode or without signal
locked.
Native aspect ratio is not applicable when zoom is
set to Zoom.
zoom = ? 0 = Off
1 = Crop
2 = Zoom
Overscan
Not applicable in STANDBY mode or without signal
locked.
Zoom is not applicable when aspect ratio is set to
Native.
h.total = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
Only applicable when the source is either VGA or
Component.
h.pos = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
h.phase = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
Only applicable when the source is either VGA or
Component.
v.pos = ? + - 0 ~ 200 Not applicable in STANDBY mode or without signal
locked.
continued on next page...
Notes