dji MATRICE 350 RTK - Page 94

MATRICE 350 RTK User Manual
94
©
2023 DJI All Rights Reserved.
• When Smart Track is enabled, a tracking frame will appear and select the target, and
the cross hairs in the center of the zoom lens will turn green, indicating that tracking
is in progress. If no target is conrmed, the tracking frame will not appear and the
app will display the message "Searching for targets ..." If the target is blocked or lost,
the device will predict and search for the trajectory of the target until it is reacquired
before resuming the tracking. Otherwise, the device will quit Smart Track.
• If the user is selecting other types of targets by gesturing on the screen, any person,
vehicle or boat that appears in the frame will be selected as the target and tracked.
• An object cannot be selected using gestures if the features of the object are not clear.
Tracking a Target
The gimbal mode will default to follow mode, and the camera will default to AFC mode when
Smart Track is enabled.
In gimbal follow mode, the orientation of the aircraft is always consistent with that of the
gimbal, both aiming at the target. The attitude of the gimbal will be adjusted automatically to
situate the target in the center, while the camera will adjust its zoom to re-size the target. The
user can ne-tune the size of the target in the eld of view using the right dial of the remote
controller.
Target Prediction: if a target is lost, the device will predict the motion trajectory and the gimbal
will rotate automatically to search for the target.
Target Search: if the target is lost, the device will automatically search for its based on its
predicted position. The user can also manually control the gimbal rotation and camera zoom to
nd the target.
Target positioning: the GNSS position of the target will be displayed in the navigation display
and map (note that when the laser rangefinder of the H20N or the H20 series gimbal and
camera continues to be invalid, the target position is for reference only), the position of the
target will also be displayed in the FPV view.
Focus Tracking: the camera focus will be adjusted according to the distance of the target object.
In gimbal follow mode, “Smart Track” will be displayed on the top bar during tracking. The
control mode of the aircraft is slightly dierent from its normal ight mode. Make sure you are
familiar with the following controls and y with caution.
Operation on
Remote Controller
Action Performed Reminders
Pressing and holding
the Pause button
Exits Smart Track. /
Yaw stick Adjusts yaw movement of
gimbal
The adjustable range is limited
during tracking.