OPERATION
3-46 25257 Issue 3 November 2013
• Counter overrun: Used to reset a counter when it is linked to another
counter (e.g. lot numbering).
• Digital input: To reset a counter using an external signal (e.g. sensor,
external button etc.
Reset-source: Defines the source of reset based on the type of source
selected above. If the type of incremental source is:
• Digital input: Select the input number.
• Counter overrun: Select the counter to which it will be linked.
• After each message group: Select the group on which the message is
loaded.
Set counter output: Function used when the counter interacts with an
external output of the machine. Select which output the counter is to
interact with.
Reset counter output: Once the output has been activated this function
allows the method by which it will be reset to be selected:
• With the next reset: Operator will need to activate the reset.
• With the next increment: No action is needed - the reset is done
automatically.
To Next Page
Loading...
