Vigor2925 Series User’s Guide
199
WAN Connection
Detection
Such function allows you to verify whether network
connection is alive or not through NS Detect or Ping Detect.
Mode – Choose NS Detect, Ping Detect or Always On for
the system to execute for WAN detection.
Always On - The network based on IPv6 will be kept
connected.
Ping Detect – If you choose Ping Detect as detection mode,
you have to type IP address or hostname for pinging.
Ping IP/Hostname –If you choose Ping Detect as
detection mode, you have to type IP address in this field
for pinging.
TTL (Time to Live) –If you choose Ping Detect as
detection mode, you have to type TTL value.
Bridge Mode
Enable Bridge Mode - If the function is enabled, the router
will work as a bridge modem.
Enable Firewall – It is available when Bridge Mode is
enabled. When both Bridge Mode and Firewall check boxes
are enabled, the settings configured (user profiles) under
User Management will be ignored. And all of the filter rules
defined and enabled in Firewall menu will be activated.
Bridge Subnet – Make a bridge between the selected LAN
subnet and such WAN interface.
After finished the above settings, click OK to save the settings.
To Next Page
Loading...
Need help?
General
