Draytek Vigor2925 Series - Page 759

Vigor2925 Series User’s Guide
743
ssid[ssid_num enable
ssid_name]
It means to set the name of the SSID, hide the SSID if
required.
ssid_num: Type 1, 2, 3 or 4 to specify SSID1, SSID2, SSID3
or SSID4.
ssid_name: Give a name for the specified SSID.
ssid hide [ssid_num enab
le]
It means to hide the name of the SSID if required.
ssid_num: Type 1, 2, 3 or 4 to specify SSID1, SSID2, SSID3
or SSID4.
enable: Type 0 to hide the SSID or 1 to display the SSID.
ssid show
It means to display a table of SSID configuration.
ratectl [ssid_num enable
upload download]
It means to set the rate control for the specified SSID.
ssid_num: Choose 1, 2, 3 or 4 to specify SSID1, SSID2,
SSID3 or SSID4.
enable: It means to enable the function of the rate control for
the specified SSID. 0: disable and 1:enable.
upload: It means to configure the rate control for data upload.
The unit is kbps.
download: It means to configure the rate control for data
download. The unit is kbps.
(example:
wl dual config ratectl 1 1 25 25)
ratectl show
It means to display the data transmission rate (upload and
download) for SSID1, SSID2, SSID3 and SSID4.
isolate lan [ssid_num
enable]
It means to isolate the wireless connection from LAN.
It can make the wireless clients (stations) with remote-dial
and LAN to LAN users not accessing for each other.
ssid_num: Choose 1, 2, 3 or 4 to specify SSID1, SSID2,
SSID3 or SSID4.
enable: It means to enable such function.
0: disable and 1:enable
isolate member [ssid_num
enable]
It means to isolate the wireless connection from Member.
It can make the wireless clients (stations) with the same SSID
not accessing for each other.
ssid_num: Choose 1, 2, 3 or 4 to specify SSID1, SSID2,
SSID3 or SSID4.
enable: It means to enable such function.
0: disable and 1:enable.
isolate vpn [ssid_num
enable]
It means to isolate the wireless connection from VPN.
ssid_num: Choose 1, 2, 3 or 4 to specify SSID1, SSID2,
SSID3 or SSID4.
enable: It means to enable such function.
0: disable and 1:enable.
isolate show
It means to display the status of wireless isolation.
E
E
x
x
a
a
m
m
p
p
l
l
e
e