dSPACE DS1103 Hardware Installation And Configuration

■■
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■ ▼ Using the AutoBoot Option
DS1103 Hardware Installation and Configuration March 2004
151
▲ ■■■■■■■■■■I
▲■■■■■■■■■■■■■■■
N
The program loader ld1103ab assumes 300H as the board’s I/O
base address by default. If you changed this address, specify the
modified address as a command line option in the autoboot.bat
file, for example,
ld1103ab smd1103a /b ds1103 /p 0x320
4 Save the changes of the autoboot.bat file to the
CompactFlash card.
E
Suppose you want to autoboot the demo application
%DSPACE_ROOT%\Demos\DS1103\AbxBoot\Host\smd1103_ab.ppc on
the respective board installed in your expansion box. The
autoboot.bat of the CompactFlash card should now read as
follows:
ld1103ab smd1103a /b ds1103 /p 0x300
5 Remove the CompactFlash card from the host PC.
6 Insert CompactFlash card with the aid of the PC Card adapter in
the PC card reader of the expansion box.
7 Turn on the expansion box.
During the boot process With the CompactFlash card inserted in the PC card reader of the
expansion box, the following steps will be performed during the boot
process:
1.
config.sys from the on-board-flash memory of slot CPU in the
expansion box loads driver and configuration files.
2. autoexec.bat from the on-board-flash memory of the slot CPU
card in the expansion box calls up the
autoboot.bat from the
CompactFlash card.
3. autoboot.bat starts your application.
T
■ You can connect the host PC to the expansion box when the
autoboot application is running: see How to Connect the PC to the
Expansion Box when the Autoboot Application is Running on
page 153.

dSPACE DS1103 Specifications

General

Brand	dSPACE
Model	DS1103
Category	Controller
Language	English