dSPACE DS1103 Hardware Installation And Configuration

■
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■ ▼ Troubleshooting
DS1103 Hardware Installation and Configuration March 2004
243
▲ ■■■■■■■■■■I
▲■■■■■■■■■■■■■■■
TCP/IP Protocol
When you check the installation of the TCP/IP protocol with the ping
command, the following error messages may occur:
Error message Bad command or file name
The TCP/IP protocol has not been installed properly.
➤ Install the TCP/IP protocol again.
Error message The name specified is not recognized as an internal or
external command, operable program or batch file
The TCP/IP protocol has not been installed properly.
➤ Install the TCP/IP protocol again.
Error message Unable to contact IP driver, error code x
The TCP/IP protocol has not been installed properly.
➤ Install the TCP/IP protocol again.
Error message Pinging 127.0.0.1 with x bytes of data:
Request timed out
The TCP/IP protocol has not been configured properly.
➤ Check the configuration of the TCP/IP protocol. If you are
uncertain, ask your system administrator.

dSPACE DS1103 Specifications

General

Brand	dSPACE
Model	DS1103
Category	Controller
Language	English