EasyManua.ls Logo

dSPACE DS1103 - Page 65

Default Icon
254 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ā– 
ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– 
ā–¼
Connecting an Expansion Box to the Host PC
DS1103 Hardware Installation and Configuration March 2004
65
ā–²
ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– I
ā–²ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– ā– 
To supply power to the DS830 via mains socket
āž¤ To install your system in a laboratory, use the cable with the
integrated power supply unit. Plug the power supply cable into the
LEMO connector of the DS830.
To supply power to the DS830 via car battery
āž¤ To install your system in a vehicle, use the cable with the
unterminated end and connect this end to the car battery. Use a
5 A fuse to protect the DS830.
The illustration below shows how to supply power to the DS830 if
installed in a vehicle.
N
It is highly recommended to insert a fuse into the main power
supply wire. The fuse should be installed close to the battery.
If you connect the red wire to the car battery directly, the DS830 will
always be turned on, and the car battery will soon run down if the
engine does not operate. Thus, a switch is highly recommended.
N
Use only a switch and wires that are designed for at least 5 A.
DS830/x
Car battery
(12 V)
Red wire
Black wire
5 A fuse
+
ā€“
(close to battery)

Table of Contents

Other manuals for dSPACE DS1103

Preview: Hardware Installation And Configuration Manual
Hardware Installation And Configuration Manual302 pages

Related product manuals