Setting Up an Ethernet Connection Between PC and Expansion Box
▲
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
DS1103 Hardware Installation and Configuration March 2004
I■■■■■■■■■■■■■
▼
72
■■■■■■■■■■■■■■■▼
How to Install the TCP/IP Protocol on the PC
(Windows NT 4.0)
You can install the TCP/IP protocol only if a network adapter is installed
on your host PC.
To install and configure the TCP/IP protocol on the host PC
1 Insert the Windows NT 4.0 CD.
2 From the Start menu, choose Settings - Control Panel.
3 Double-click Network in the Control Panel.
The Network dialog opens.
4 Select the Protocols page. If TCP/IP is already installed, proceed
with step 9. Otherwise, click Add.
5 Select TCP/IP Protocol, and click OK.
6 The Setup dialog opens. You are asked if you want a DHCP Server
to dynamically provide an IP address. Click No to choose the
IP address yourself.
Windows NT copies files.
7 In the Network dialog, click Close.
The TCP/IP protocol will now be installed.
8 The Microsoft TCP/IP Properties dialog opens. Select the IP
Address page. Proceed with step 11.
9 Click TCP/IP Protocol, and select Properties.
10 Select the IP Address page.
11 Select Specify an IP Address. Enter the value
192.100.100.1
in
the IP Address edit field.
12 In the Subnet Mask edit field, enter the value
255.255.255.0
.
13 Click OK to close the TCP/IP Properties dialog.
14 Click OK to close the Network dialog.
15 When prompted, confirm to restart the host PC.
To Next Page
Loading...
Need help?
General
