dSPACE DS1103 Hardware Installation And Configuration

■
■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■ ▼ Setting Up an Ethernet Connection Between PC and Expansion Box
DS1103 Hardware Installation and Configuration March 2004
73
▲ ■■■■■■■■■■I
▲■■■■■■■■■■■■■■■
16 Check the correct installation of the TCP/IP protocol on the
host PC:
In a DOS window, enter the command: ping 127.0.0.1
If the TCP/IP protocol is installed properly, the following message
will appear (the values vary for different computers and networks):
Pinging 127.0.0.1 with 32 bytes of data:
Reply from 127.0.0.1: bytes=32 time<10ms TTL=32
Reply from 127.0.0.1: bytes=32 time<10ms TTL=32
Reply from 127.0.0.1: bytes=32 time<10ms TTL=32
Reply from 127.0.0.1: bytes=32 time<10ms TTL=32
17 Proceed with
• How to Set Up a Peer-to-Peer Connection (Windows NT 4.0)
on page 75 or
• How to Integrate the Expansion Box into a Network
(Windows NT 4.0) on page 78.
T
If any problem comes up when you install the TCP/IP protocol, see
Expansion Box (Ethernet Connection) on page 241 in the
troubleshooting chapter.

dSPACE DS1103 Specifications

General

Brand	dSPACE
Model	DS1103
Category	Controller
Language	English