dSPACE DS1103 Hardware Installation And Configuration

Setting Up an Ethernet Connection Between PC and Expansion Box ▲ ■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■■
■
DS1103 Hardware Installation and Configuration March 2004
I■■■■■■■■■■■■■ ▼
90
■■■■■■■■■■■■■■■▼
To set up and test a peer-to-peer connection
1 If the host PC is already part of an existing network, switch it off,
and disconnect it from the network.
2 Connect the expansion box to the host PC, using the supplied
crossed-over patch cable.
N
For a peer-to-peer connection, the crossed-over patch cable
supplied with the expansion box must be used. If connecting to an
existing network, for example, via a hub, a standard patch cable
must probably be used. If you are uncertain, ask your network
administrator.
3 Turn on the expansion box.
During booting, the expansion box beeps several times. The last
beep sequence indicates whether the default IP address is active
(three short beeps) or if the IP address has been changed by the
user (one long beep). In the following it is assumed that the
default IP address (192.100.100.98) is active.

dSPACE DS1103 Specifications

General

Brand	dSPACE
Model	DS1103
Category	Controller
Language	English