ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā
ā¼
Setting Up an Ethernet Connection Between PC and Expansion Box
DS1103 Hardware Installation and Configuration March 2004
99
ā²
ā ā ā ā ā ā ā ā ā ā I
ā²ā ā ā ā ā ā ā ā ā ā ā ā ā ā ā
N
ā
member
is the only keyword in the group description file. Lines that
start with an unknown keyword are ignored. They are not handled
as errors.
ā Group names and network aliases must not consist of more than
15 characters (ASCII ā no spaces).
The initial
%DSPACE_ROOT%\CONFIG\dsgroups.ini
file contains an
example of a group description.
Accessing a
multiconnect group
Since a multiconnect group is handled in the same way as a single
network client, you connect it via the Change Connection dialog. For
details, refer to How to Set the Connection Mode on page 103.
To Next Page
Loading...
