DURKOPP ADLER 513 - 4.12 Performing a Manual Test Run

Programming
Operating Instructions 513/533 - 01.0 - 09/2023 65
Fig. 49: Set button sewing function (for 533) (2)
7. Use the buttons to set the value to 7.
8. To save the settings, press the button.
 The settings are saved and the message appears that
machining is in progress and the machine must NOT be
switched off.
 After a short time the message appears that the machine
can be switched off
9. Switch off the machine.
10. Switch machine on again.
 The button sewing function is now active and the machine is
ready for sewing.
4.12 Performing a manual test run
To check if the selected standard seam pattern matches
the installed clamp, you can perform a manual test run.
To perform a manual test run:
1. Press the button.
2. Select the desired standard seam pattern using the
buttons.
3. Press the button.
4. Press the button.
 The machine enters the manual test run mode.