Operation
Operating Instructions 513/533 - 01.0 - 09/2023 15
3 Operation
3.1 Threading the needle thread
To thread the needle thread:
1. Fit the thread reels on the reel stand and feed the needle and
hook threads through the unwinding bracket.
The unwinding bracket must stand horizontally above the
thread reels.
2. Thread the needle thread as shown in the following figure.
Fig. 1: Threading the needle thread
3. Pull the needle thread approx. 4 cm through the needle after
threading.
This ensures reliable sewing-on.
CAUTION
Risk of injury from sharp and moving parts!
Crushing or puncture possible.
Only thread the needle thread with the machine
switched off.
(1) - Silicone lubricator (optional)
To Next Page
Loading...
Need help?
General
