Setup
96 Operating Instructions 513/533 - 01.0 - 09/2023
6.3.9 Electrical connection
6.3.10 Checking the mains voltage
The voltage specified on the control type plate must agree with
the mains voltage used.
6.3.11 Mounting line filter
Fig. 66: Mounting line filter
To mount the line filter:
1. Insert the line filter (1) through the hole in the tabletop (2).
2. Screw the line filter (1) to the tabletop (2) with 4 screws from
the accessory pack.
DANGER
Risk of injury from electricity!
Unprotected contact with electricity can result in
serious injuries or death.
Work on the electrical system must ONLY be
carried out by qualified electricians or
appropriately trained and authorized personnel.
ALWAYS pull the power plug before working on
the electrical equipment.
(1) - Line filter (2) - Tabletop
To Next Page
Loading...
Need help?
General
