DURKOPP ADLER 513 - Changing the Seam Pattern Parameters (P)

Programming
32 Operating Instructions 513/533 - 01.0 - 09/2023
2. Press the buttons to change the number of the seam
pattern.
3. Press the buttons to change the mode of the seam
pattern:
4.2.2 Changing the seam pattern parameters (P)
Symbol Explanation
Standard seam patterns
Stored on the machine are the standard seam patterns
001 through 100. The customer can import standard
seam patterns bearing the numbers 101 to 200
( p. 60).
Seam patterns (P)
The seam patterns (P) are registered at program slots
P1 to P99 based on the standard seam patterns
( p. 45).
Seam pattern sequence (C)
The customer can create a seam pattern sequence (C)
from multiple seam patterns (P) (up to 99). The maximum
number of seam pattern sequences (C) is 99.
CAUTION
Crushing possible!
The movement of the sewing foot can lead to
crushing injuries of the fingers.
Keep your fingers out of the sewing area.
NOTICE
Property damage may occur!
If the set value is outside of the sewing area, the sewing foot
may collide with the needle, resulting in needle breakage.
Only enter values that are within the sewing area!