Programming
Operating Instructions 513/533 - 01.0 - 09/2023 45
4.4 Registering a new seam pattern (P)
The following gives an example of how to register a new seam
pattern (P). The standard seam patterns are created on the com-
puter with the help of the Pattern Design software (which can be
ordered from Dürkopp Adler under material number 0513 590024).
The standard seam patterns will afterwards be imported to the
machine and can then be registered.
Example of how to create a seam pattern
• Save seam pattern no. 3 to P2
• X-scaling 50%
• Y-scaling 80%
• Speed 2000rpm
• Zero point X-axis 0.5
• Zero point Y-axis -1.0
To create a new seam pattern:
1. Switch on the machine.
2. Press the button.
The system menu appears.
Fig. 28: Registering a new seam pattern (1)
3. Use the buttons to select 04 Reg P pat.
4. Press the button to call up the seam pattern registration
mode.
5. Press the button.
6. Use the buttons to edit the data.
To Next Page
Loading...
