DURKOPP ADLER 513 - Table of Contents

Table of Contents
Operating Instructions 513/533 - 01.0 - 09/2023 1
1 About these instructions .................................................................... 5
1.1 For whom are these instructions intended? ..........................................5
1.2 Representation conventions – symbols and characters........................6
1.3 Other documents...................................................................................7
1.4 Liability ..................................................................................................8
2 Safety.................................................................................................... 9
2.1 Basic safety instructions........................................................................9
2.2 Signal words and symbols used in warnings....................................... 11
3 Operation ........................................................................................... 15
3.1 Threading the needle thread ...............................................................15
3.2 Adjusting the needle thread tension .................................................... 16
3.3 Adjusting the needle thread regulator .................................................17
3.4 Winding the hook thread .....................................................................19
3.5 Changing the bobbin ...........................................................................20
3.6 Adjusting the hook thread tension .......................................................22
3.7 Changing the needle ...........................................................................23
3.8 Adjusting the button mount of the button clamp (Class 533)............... 25
3.9 Shank shaper (optional) ......................................................................27
4 Programming .....................................................................................29
4.1 Control panel .......................................................................................29
4.2 Basic settings ......................................................................................31
4.2.1 Selecting a seam pattern.....................................................................31
4.2.2 Changing the seam pattern parameters (P) ........................................32
4.2.3 Checking seam patterns (P)................................................................34
4.2.4 Changing seam patterns (P) ...............................................................35
4.2.5 Sewing.................................................................................................36
4.2.6 Winding the thread ..............................................................................37
4.2.7 Pausing sewing ...................................................................................38
4.2.8 Shifting the zero point..........................................................................40
4.3 Counter................................................................................................41
4.3.1 Adjusting/changing the counter ...........................................................41
4.3.2 Setting the counter mode ....................................................................43
4.3.3 Resetting the counter ..........................................................................44
4.4 Registering a new seam pattern (P)....................................................45
4.5 Using a seam pattern sequence (C)....................................................50
4.5.1 Selecting seam patterns (P) for a seam pattern sequence (C) ...........50
4.5.2 Changing a seam pattern sequence (C) .............................................51
4.5.3 Sewing a seam pattern sequence (C) .................................................52
4.5.4 Copying/deleting a seam pattern sequence (C) ..................................53
4.6 Setting the parameters ........................................................................54
4.7 Parameter list ......................................................................................55