DURKOPP ADLER 513 - Counter; Adjusting;Changing the Counter

Programming
Operating Instructions 513/533 - 01.0 - 09/2023 41
2. Press the button.
 You can now adjust the alignment of the clamp relative
to the needle hole.
3. Press the buttons to adjust the X-axis.
4. Press the buttons to adjust the Y-axis.
5. Press the button.
 The values are stored, and the machine is ready for sewing.
4.3 Counter
4.3.1 Adjusting/changing the counter
Calling up the Counter menu
Fig. 23: Adjusting/changing the counter (1)
Variant A for calling up the counter:
1. When in programming mode (LED off), press the button.
2. Use the buttons to select 02 Sew Counter.
3. Press the button.
 The submenu is displayed and allows you to adjust
the counter: