8.5 Checking input elements
The programme serves for checking the input elements.
–
Select the function "
Checking input elements
".
–
Operate the input element to be checked.
–
The display shows the circuit diagram code and the circuit state of
the modified input element (e.g. "
+S17
").
The display changes when the circuit state changes or if any other
input element is modified. A change of the circuit state will be
indicated by an acoustic signal.
–
Press the function key "
F1
" in order to quit the checking programme
–
Input- Function
element
S01 Thread monitor
S02 Outer frame in front position
S03 Outer frame in rear position
S04 Light barrier Automatic Vacuum
S06 Outer frame in upper position
S07 Outer frame - counter air at top
S08 Outer frame in lower position
S09 Outer frame - counter air at bottom
S10 Middle slide in upper position
S11 Middle slide in lower position
S12 Middle slide in front position
S14 Middle slide, half way
S15 Middle slide in rear position
S16 Coding B stacker
S17 Coding A sewing head
S18 Coding B sewing head
S19 Coding C sewing head
S21 Sewing head in lower position
S22 Sewing head in upper position
S23 Hook flapS24lower thread monitor
S29 Stacker switch
S30 Roll-out light barrier
S31 Advance roller switch
S32 Coding A stacker
S33 X reference point
S34 Transfer plate Code
S35 Start key
S36 Middle slide lifting/lowering
S37 Vacuum
S38 Pressure monitor
S45 X end position
S49 Emergency stop relay
S50 Emergency stop key
S51 O-key
S52 Cycle free
S53 Repetition
S54 Safe zero stop
S55 Safe stop time
S56 Sm error
S59 Y end position
S60 Y reference point
S61 Transfer plate available
S62 Transfer plate in upper position
S63 Transfer plate in lower position
S64 Inner slide in rear position
102
To Next Page
Loading...
