DURKOPP ADLER 806 - Description and Adjustment of the Integrated Adjustment Disk

3.1.2 Description and adjustment of the integrated setting disk
By means of the locking pin 1 and the integrated setting disk 2, located
on the toothed belt pulley, the machine can be locked in any setting
position.
The setting disk is provided for this purpose with 6 incisions, marked
on the handwheel by the letters
A, B, C, D, E
and
F
. The letters
indicate the position, in which the machine can be locked by the pin 1.
The
A
incision (loop stroke position) is deeper than the other incisions.
Settings in the different positions:
A
Setting disk in respect to the groove in the arm shaft crank,
parallelism,
belt pulley, loop stroke, distance of the hook tip to the needle
C
2
nd
needle position
D
Control cam for the thread cutter
E
Needle bar height
OT
Upper dead centre
Setting the phase position of the lifting eccentric
1
A
E
F
D
C
B
1
2
OT
42