6. Adjustment options
All adjustments described in this section are made before delivering
the machine. Should the adjustments get lost, they must be restored
manually.
Following parameters are set with this menu:
–
Machine class
–
Remaining thread monitor available
–
End position switch of the transfer carriage available
–
Measuring the end positions of the transfer carriage
–
Distance balance of the transfer carriage
Calling up adjustment menu
–
Press the key "
F2
" when switching on the machine.
The adjustment menu will appear some moments later
Note:
The machine will automatically be branched into this menu if the basic
adjustments of the 806 are lost.
Quit the adjustment menu
–
When all adjustments have been made, the symbol "<<" will
appear above the F1 key.
–
Press the key "
F1
".
The adjustment menu will be quitted and the sewing unit will be
restarted.
6.1 Selecting the machine class
Rule and control
The programming of the 806 has been done in a way that all classes of
the 806 are getting the same Software.
–
One of the following symbols is marked as a machine class :
806-111 (with machine head 467)
806-121 (with machine head 271)
806-121 (with machine head 396)
–
The marked symbol must correspond to the machine class.
Correction
–
Mark the symbol that corresponds to the available machine class.
6.2 Remaining thread monitor (only 806-121)
By means of the function "
Remaining thread monitor available
" the
sub-class 806-121 can be set to show whether a remaining thread
monitor is available. The symbol can only be selected if the sub-class
806-121 has been adjusted accordingly.
Note:
The remaining thread monitor will not be switched on or off by this
function.
90
To Next Page
Loading...
